Project cases

12 pontoon piles Wilhelmshaven

February 5, 2025
In June 2024, Ballast Nedam successfully installed 12 access pontoon piles at Wilhelmshaven in northern Germany using the CAPE VLT-160 and S-150 impact hammer. The entire project was completed in less than two weeks.

8 Jacket skirt piles for Hai Long Sub Stations

January 21, 2025
In 2024, the CAPE VLT-640 Tandem was deployed to install 8 piles with a diameter of 4.4 meter, a length of 103.5 meter and a maximum weight of 935t for two offshore sub stations for phase one of the Hai Long Offshore Wind project in Taiwanese waters.

29 Flanged monopiles for Moray West OWF

September 17, 2024
Between February 2024 and April 2024, the CAPE VLT-640 Quad was used by installation contractor DEME on board of its Offshore Heavy Lift DP3 installation vessel Orion to install 29 flanged monopiles with a bottom diameter up to 10 meters and a length of up to 91 meters for the…

12 Flanged monopiles for Moray West OWF

September 9, 2024
Between November 2023 and March 2024, the CAPE VLT-640 Triple was used by installation contractor Boskalis on board its Heavy Lift Vessel Bokalift 2 to install 12 flanged monopiles with a bottom diameter of up to 10 meters and a length of up to 91 meters for Ocean Winds' Moray…

188 pin piles for Formosa 2 OWF

February 13, 2023
Starting in 2020, a CAPE VLT-320 has been used to upend and drive pin piles with a diameter of 96 inches through a pre-piling template at the Formosa 2 Offshore Wind project.

65 combi wall piles

January 19, 2023
In 2022, the CAPE VLT-80 was used to upend and install 65 combi wall piles with a length of 29.25m for the renovation of the Royerssluis/lock and Oosterweelknoop in Antwerp, Belgium.